Restauration of Pamor

[mariusgmioc]

Originally Posted by David

The technique for staining blades is done with warangan (arsenic and lime). If you search the site you should find some instructions on this, though obtaining arsenic can be difficult for many. Some people use industrial grade arsenic which gives a fairly consistent result while many grind up the actual mineral for the process which can be less consistent, but might be easier to get your hands on.
There are people who do this as a service, but few outside of Indonesia. Where do you live?

Thank you very much for your reply!

I live in the Netherlands, and here only asking about arsenic can land you in hot water. So there is no way I can legally get it. However, I will travel next month to Indonesia, so if you know any place there would be quite helpful.

[David]

There are an awful lot of keris collectors (and keris) in The Netherlands. Perhaps there is someone there who does traditional warangan treatments.
I cannot tell you much about who can do this for you in Indonesia. Perhaps others can help you there.

[mariusgmioc]

Originally Posted by David

There are an awful lot of keris collectors (and keris) in The Netherlands. Perhaps there is someone there who does traditional warangan treatments.
I cannot tell you much about who can do this for you in Indonesia. Perhaps others can help you there.

Thank you for trying!
I know a keris dealer here who might help.
In the worst case I will start experimenting myself with the chemicals I have.

[David]

Originally Posted by mariusgmioc

In the worst case I will start experimenting myself with the chemicals I have.

Well, as i state before, there is a bit of material in our archives on staining keris blades, including many suggestions on alternatives to using arsenic. Give a search and see what you find.

[Rafngard]

Is anyone doing this in the U.S? I have a blade or two that could use an etch. I mentioned the possibility of trying this at home to my significant other, and her eyes got wide, and, well, let's just say I'm glad she didn't have a keris handy.

Thanks,
Leif

[semar]

hello depends ware you will go when you go to yogyakarta ik can help you with that i know 2 tukang maranggi

regards semar

[mariusgmioc]

Originally Posted by semar

hello depends ware you will go when you go to yogyakarta ik can help you with that i know 2 tukang maranggi

regards semar

Thank you for your assitance!

Yes, I will go to Yogyakarta in May and I can take the Wedhung with me to have it etched.

So, any more information will be welcomed!

Best regards,

Marius

[ariel]

Originally Posted by Rafngard

Is anyone doing this in the U.S? I have a blade or two that could use an etch. I mentioned the possibility of trying this at home to my significant other, and her eyes got wide, and, well, let's just say I'm glad she didn't have a keris handy.

Thanks,
Leif

Buy Selenium Dioxide on Amazon. Cheap, reliable, safe, perfect blueing for guns and knives.

[David]

Originally Posted by ariel

Buy Selenium Dioxide on Amazon. Cheap, reliable, safe, perfect blueing for guns and knives.

Ariel is no doubt correct that Selenium Dioxide will raise the pamor on your blade. It won't give you the correct traditional coloring that arsenic will render. So in the end it all depends on your preferences and how authentic you want your blade to look in the end.