Brass bits on a Jamdhar Katari

Atlantia · 21st October 2011, 01:15 AM

You don't think it's the remains of koftgari?

archer · 21st October 2011, 01:34 AM

I don't see any signs of cross hatching used in koftgari. There is a similar effect
adding wire fill to holes. So far most of the dots are in less exposed areas. It may just mean the "Brass" was better protected in these locations. i added the most recent close ups.

kai · 21st October 2011, 08:53 AM

Quote:

I don't see any signs of cross hatching used in koftgari.

If koftgari, I doubt you would be able to still see the cross hatching in such a corroded condition.

If you really were to restore this (close) to working order rather than keeping it in relic condition, I'd either choose "sandblasting" (with softer beads than sand), electrolytic rust removal (http://www.vikingsword.com/vb/showthread.php?t=1174), or the pineapple juice approach (search the keris forum). All have pros and cons, so take your time for reaching any decision.

Regards,
Kai

21st October 2011, 01:34 AM	#2
archer Member Join Date: Mar 2005 Posts: 373	I don't see any signs of cross hatching used in koftgari. There is a similar effect adding wire fill to holes. So far most of the dots are in less exposed areas. It may just mean the "Brass" was better protected in these locations. i added the most recent close ups. Attached Images

21st October 2011, 01:15 AM	#1
Atlantia Member Join Date: Jun 2008 Location: The Sharp end Posts: 2,928	You don't think it's the remains of koftgari?