Wheellock Mechanism

Matchlock · 28th August 2011, 06:29 PM

Hi Rick,

Very attractive piece, as expected!

Everything else, apart from the missing parts, seems to be all complete and original, preserved in very good condition. The scrollwork engraving on the dogs also is characteristic of Italy, ca. 1590.

And you are absolutely right about the fact that these complicated wheellock mechanisms sure needed a lot of permanent attention and maintenance. Looks like your lock mechanism got damaged during use in its early years and taken out of the musket for repair which it actually never saw. The point about these Italian locks are that they usually had very strong springs, with the weakest parts being the chain and sear. Yours, too, should have strong springs.

I do think it will add to the value when it is correctly repaired. Just patinate the replaced minor parts to optically match.

Congratulations again,
Michael

rickystl · 28th August 2011, 10:38 PM

Hi Michael. Yes, I'm very pleased with it. And the fact that I did not have to over-pay for it makes it even better. It will probably be a couple months before I can start on the new parts. Too many other restoration projects already in the works.

I'll post before and after photos once the work is complete. Also, if the new proposed restoation section on the Forum comes about, this would be a good candadite to post.
In your opinion, would I be wrong to say this Lock was probably made between say 1580 and 1610? Thanks, Rick.

Matchlock · 29th August 2011, 05:34 PM

Hi Rick,

an assigned date of 'ca. 1590-1600' would be as close as possible in my opinion.

Best,
Michael

rickystl · 29th August 2011, 05:42 PM

Quote:

Originally Posted by Matchlock

Hi Rick,

an assigned date of 'ca. 1590-1600' would be as close as possible in my opinion.

Best,
Michael

OK, thanks Michael. Your opinion DOES count.

Rick.

Matchlock · 29th August 2011, 10:18 PM

I do hope so, Rick,

Thanks a whole lot!

Best,
Michael

fernando · 4th September 2011, 02:54 PM

Another fascinating wheel lock.
Made in the XVII century, signed by Neuriter of Prague, a city belonging at the time to the Roman Holly Empire of Germany.
A pity the original picture is too bright and i could not get a better scan; still we can see Neptuno inciting his sea horses to pull his charriot.

.

rickystl · 5th September 2011, 02:14 PM

Hi Fernando. A lock that tells a story. Thanks for posting. Imagine how long it must have taken to do all the engraving and chisel work on this lock.
I've read where the Germans were so fasinated with the Wheellock, that they continued to use them well into the 18th Century on sporting arms. Rick.

4th September 2011, 02:54 PM	#6
fernando (deceased) Join Date: Dec 2004 Location: Portugal Posts: 9,694	Another fascinating wheel lock. Made in the XVII century, signed by Neuriter of Prague, a city belonging at the time to the Roman Holly Empire of Germany. A pity the original picture is too bright and i could not get a better scan; still we can see Neptuno inciting his sea horses to pull his charriot. . Attached Images

28th August 2011, 06:29 PM	#1
Matchlock (deceased) Join Date: Sep 2008 Location: Bavaria, Germany - the center of 15th and 16th century gunmaking Posts: 4,310	Hi Rick, Very attractive piece, as expected! Everything else, apart from the missing parts, seems to be all complete and original, preserved in very good condition. The scrollwork engraving on the dogs also is characteristic of Italy, ca. 1590. And you are absolutely right about the fact that these complicated wheellock mechanisms sure needed a lot of permanent attention and maintenance. Looks like your lock mechanism got damaged during use in its early years and taken out of the musket for repair which it actually never saw. The point about these Italian locks are that they usually had very strong springs, with the weakest parts being the chain and sear. Yours, too, should have strong springs. I do think it will add to the value when it is correctly repaired. Just patinate the replaced minor parts to optically match. Congratulations again, Michael

28th August 2011, 10:38 PM	#2
rickystl Member Join Date: Jul 2010 Location: St. Louis, MO area. Posts: 1,633	Hi Michael. Yes, I'm very pleased with it. And the fact that I did not have to over-pay for it makes it even better. It will probably be a couple months before I can start on the new parts. Too many other restoration projects already in the works. I'll post before and after photos once the work is complete. Also, if the new proposed restoation section on the Forum comes about, this would be a good candadite to post. In your opinion, would I be wrong to say this Lock was probably made between say 1580 and 1610? Thanks, Rick.

29th August 2011, 05:34 PM	#3
Matchlock (deceased) Join Date: Sep 2008 Location: Bavaria, Germany - the center of 15th and 16th century gunmaking Posts: 4,310	Hi Rick, an assigned date of 'ca. 1590-1600' would be as close as possible in my opinion. Best, Michael

29th August 2011, 10:18 PM	#5
Matchlock (deceased) Join Date: Sep 2008 Location: Bavaria, Germany - the center of 15th and 16th century gunmaking Posts: 4,310	I do hope so, Rick, Thanks a whole lot! Best, Michael

5th September 2011, 02:14 PM	#7
rickystl Member Join Date: Jul 2010 Location: St. Louis, MO area. Posts: 1,633	Hi Fernando. A lock that tells a story. Thanks for posting. Imagine how long it must have taken to do all the engraving and chisel work on this lock. I've read where the Germans were so fasinated with the Wheellock, that they continued to use them well into the 18th Century on sporting arms. Rick.