Binding Rattan

Oriental-Arms · 4th July 2006, 01:09 PM

Charles asked for instructions for binding rattan, so I took few photos and send him. He tried it on a newly made barong scabbard and this is what came out:

Not bad for a novice restorer (or may be the cookbook is good). Charles suggested to post the binding instructions on the forum so all could benefit, and here they are:

Tools: Good scissors, long (not sharp) needle, sharp knife (I use a medical scalpel)
1) Immerse the rattan in room temperature water for about 20 min. until it is soft and flexible

2) The rattan has two sides: the front side which is shining and the back side which is rough

3) Start the binding from the back side of the scabbard, always going from the narrow part of it toward its wider part.

4) Start with the rattan rough side up; fold it 90 degrees so the front side is up now (see photo 1):

5) Continue binding until you get the required width of binding

6) Push the long needle below the last three-four bindings (Photo 2):

7) Push the end of the rattan fiber below the last three bindings (Photo 3)

8) Pull out the needle and tight the rattan fibers (Photo 4)

9) Fold the rattan upward and push it below the last binding (Photo 5)

4th July 2006, 01:09 PM	#1
Oriental-Arms Member Join Date: Jan 2005 Location: Haifa, Israel Posts: 183	Binding Rattan Charles asked for instructions for binding rattan, so I took few photos and send him. He tried it on a newly made barong scabbard and this is what came out: Not bad for a novice restorer (or may be the cookbook is good). Charles suggested to post the binding instructions on the forum so all could benefit, and here they are: Tools: Good scissors, long (not sharp) needle, sharp knife (I use a medical scalpel) 1) Immerse the rattan in room temperature water for about 20 min. until it is soft and flexible 2) The rattan has two sides: the front side which is shining and the back side which is rough 3) Start the binding from the back side of the scabbard, always going from the narrow part of it toward its wider part. 4) Start with the rattan rough side up; fold it 90 degrees so the front side is up now (see photo 1): 5) Continue binding until you get the required width of binding 6) Push the long needle below the last three-four bindings (Photo 2): 7) Push the end of the rattan fiber below the last three bindings (Photo 3) 8) Pull out the needle and tight the rattan fibers (Photo 4) 9) Fold the rattan upward and push it below the last binding (Photo 5)