|
23rd August 2015, 02:06 PM | #1 |
Member
Join Date: Feb 2006
Posts: 637
|
ken that is a different story. If you enjoy doing the work yourself and it is a fun project with others goodluck. In this instance he was talking about bringing it to a gunsmith. I have restored some lower end pieces and by the time I added up my cost I am in it well more than it is worth.
|
24th August 2015, 06:26 PM | #2 |
Member
Join Date: Jul 2010
Location: St. Louis, MO area.
Posts: 1,621
|
Thank you all for your comments and suggestions. Much appreciated.
Viewed from both perspectives, collector or shooter, I might have been better off not purchasing the gun at all. LOL I don't need it for my collection. And I have two other Kubur pistols in shooting order, that are both nice pieces. I just bought it as a possible project gun since it was so cheap. So here's what I'm going to do to start: 1. Put the lock in working order. I can do certain repairs and replacement work. But I can't make new springs, if needed. Forging new springs and making replacement lock parts is a specialty with this gunsmith. And my experience has shown me this won't be nearly as expensive as you would first imagine. At least not with him. And it's likely he has or can locate the ready made parts and fit them to the lock and tune it. Which will cost even less. But he will let me know. A new lockplate screw(s) will be easy. 2. I can restore the wood around the rear of the lock mortise area. But it would be much faster, and look much better if the gunsmith does it. 3. As long as the gun's there, have him remove the breech plug and give me his opinion of the inside of the barrel. If that checks out OK, and doesn't require a liner, than all is well. I'll fire it a few times, and keep it as just a shooter or have something to trade for a lower end Ethno blade or something. LOL I can always decide to remove that ugly varnish later on myself. But as Ward says, in either case, collector or shooter, there is eventually a diminishing return. Adding $200-300.00 is one thing. Adding $500.00++ is something different. At least in my view. Rick. |
26th August 2015, 06:40 PM | #3 |
Member
Join Date: Jan 2012
Posts: 402
|
i have similar problems with old pieces that are cheap because of poor condition. I buy them, thnking I can clean them up, and possibly move them on for somehing better; but after few hours work, I somehow get fond of them, and hence reluctant to sell.
My advice; don't invest too much time and effort in something you don't really want, sentiment will get in the way of sense! Regards Richard |
29th August 2015, 05:57 PM | #4 |
Member
Join Date: Jul 2010
Location: St. Louis, MO area.
Posts: 1,621
|
Hi Richard.
That is really good advice. And that's my problem also. I can't seem to part with anything. LOL I've always viewed my collecting/shooting interest as a hobby, not really to realize a future profit. But, as you say, even my sentiment will carry only so far LOL I probably won't go any more than repairing the lock and mortise area. That way I'll have an original shooter for the cost of an inexpensive Indian made replica. The bore is in surprisingly good shape. But I'll remove the breech plug and make sure, and get one other opinion besides mine on it's shootability. Again, thank you all for your comments. I'll report back with pics of the repairs, etc. Rick. |
|
|