East Indian Axe? For comment:

Royston · 20th October 2020, 09:42 PM

Do you think it may have started like this one?
If the end piece of the wooden shaft split or broke they may have inserted a "cap" into the crown at the top.
Regards
Roy

Kubur · 20th October 2020, 10:43 PM

Quote:

Originally Posted by Royston

Do you think it may have started like this one?
If the end piece of the wooden shaft split or broke they may have inserted a "cap" into the crown at the top.
Regards
Roy

Sure and yours was probably caped with a brass or iron finial.

kronckew · 21st October 2020, 09:39 AM

Anything's possible, my new one's haft looks like there is a deliberately short wider undercut section not seen on the ones with the long conical finials. Kind of like a checker nailed to a narrower cylinder. (Might even be 2 part like that in reality, will know on arrival)

The heads are in any case, all set from the butt up into a slight increasing taper at the top, like a tomahawk, rather than top down like a western axe.

20th October 2020, 09:42 PM	#1
Royston Member Join Date: Mar 2008 Location: Poole England Posts: 441	Do you think it may have started like this one? If the end piece of the wooden shaft split or broke they may have inserted a "cap" into the crown at the top. Regards Roy Attached Images

21st October 2020, 09:39 AM	#3
kronckew Member Join Date: Mar 2006 Location: Room 101, Glos. UK Posts: 4,152	Anything's possible, my new one's haft looks like there is a deliberately short wider undercut section not seen on the ones with the long conical finials. Kind of like a checker nailed to a narrower cylinder. (Might even be 2 part like that in reality, will know on arrival) The heads are in any case, all set from the butt up into a slight increasing taper at the top, like a tomahawk, rather than top down like a western axe.