Tawdry Tulwar.

Norman McCormick · 28th March 2009, 06:33 PM

Hi,
Just a quick update. Using a hot air gun to remove the hilt made it a quick and easy job, five minutes and it was done no mess. The scratches, gouges and grinder marks are so deep in places that on the 6 inches I attempted I had to resort to a selection of files, fine to ultra fine, to make any progress. I also used some fine paper but I've still a way to go. Despite the problems progress is being made. Thanks to all for their input.
Regards,
Norman.

28th March 2009, 06:33 PM	#1
Norman McCormick Member Join Date: Oct 2007 Posts: 1,618	Hi, Just a quick update. Using a hot air gun to remove the hilt made it a quick and easy job, five minutes and it was done no mess. The scratches, gouges and grinder marks are so deep in places that on the 6 inches I attempted I had to resort to a selection of files, fine to ultra fine, to make any progress. I also used some fine paper but I've still a way to go. Despite the problems progress is being made. Thanks to all for their input. Regards, Norman. Attached Images

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode