|
31st October 2008, 11:17 PM
|
#23 |
|
EAAF Staff
Join Date: Feb 2005
Location: Centerville, Kansas
Posts: 2,196
|
A few new pictures. I hope these help. I could not get a decent picture of the pommel cap where the tang is riveted over. Will try again later when the sun is less bright. The guard is either steel or iron. Hammer marks as well as file marks can be seen on the guard, unfortunately very little shows in the pictures. The quillons have flat spots on both ends and on both sides. Could this guard have possible been cast? You can also see on the one picture where the person that I got this from hit the guard with the wire wheel when he CLEANED the blade. Again let me thank everyone for their help.
Robert Last edited by Robert Coleman; 1st November 2008 at 12:39 AM. |
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Threaded Mode