Rasak Restoration.

Norman McCormick · 25th September 2008, 07:36 PM

Hi Ward,
Many thanks for the advice, I'm keen to have a go at this myself but I'll keep your kind offer in mind. I have plenty of mild steel and EN45 spring steel which I have used for making blades before but no soldering iron, easy and cheap to get though. I use epoxy a lot in blade construction would it be strong enough for this or should I stick to soldering, stronger and more appropriate? Approx how much past the present end of the sear should I be aiming to extend. Thanks again.
My Regards,
Norman.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

25th September 2008, 07:36 PM	#14
Norman McCormick Member Join Date: Oct 2007 Posts: 1,633	Hi Ward, Many thanks for the advice, I'm keen to have a go at this myself but I'll keep your kind offer in mind. I have plenty of mild steel and EN45 spring steel which I have used for making blades before but no soldering iron, easy and cheap to get though. I use epoxy a lot in blade construction would it be strong enough for this or should I stick to soldering, stronger and more appropriate? Approx how much past the present end of the sear should I be aiming to extend. Thanks again. My Regards, Norman.