Shi, Tutsi swords and others

Flavio · 17th May 2007, 10:17 PM

Quote:

Originally Posted by LOUIEBLADES

Tim

It's about time you picked one of these up Favio and I were feeling kind of guilty that we both had one and you didn't.

Lew

Hey Lew, we are not the only ones

Tim I like the patina, congrats

Bill M · 18th May 2007, 02:18 AM

Hey! I want one also.

Lew · 18th May 2007, 04:07 AM

Quote:

Originally Posted by Bill Marsh

Hey! I want one also.

Bill

You must first chant the special Shi sword mantra and have a lot of patience and a bit of luck before you can get one of these.

Tim I will take a few photos of mine over the weekend so you can do your comparison on the blades.

Lew

katana · 18th May 2007, 10:35 AM

Tim,
love the blade......could you post some close ups ?

Lew · 18th May 2007, 05:43 PM

Tim

I found one on Artzi's website for your research.

Lew

Tim Simmons · 18th May 2007, 06:22 PM

I still need one like that Lew

. Here are some close ups of this blade just enough to get the gist of it. The finger is not the most elegant measure of the blade but it does show the keen edge. The centre rib is approx 1cm wide and as I mentioned 5mm thick. The blade edge is slightly opposed curves, giving strength in structure if not the finest steel. I really like African metalwork that shows the smiths working marks. I do not think they had heard of William Morris and the arts and crafts movement

. can I see a relation to some blades further south?

Flavio · 18th May 2007, 06:50 PM

Hello Tim, here is mine

18th May 2007, 05:43 PM	#5
Lew (deceased) Join Date: Dec 2004 Location: East Coast USA Posts: 3,191	Tim I found one on Artzi's website for your research. Lew Attached Images

18th May 2007, 06:50 PM	#7
Flavio Member Join Date: Dec 2004 Location: Italia Posts: 1,243	Hello Tim, here is mine Attached Images

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

18th May 2007, 02:18 AM	#2
Bill M Member Join Date: Mar 2005 Location: USA Georgia Posts: 1,599	Hey! I want one also.

18th May 2007, 10:35 AM	#4
katana Member Join Date: Jan 2006 Location: Kent Posts: 2,658	Tim, love the blade......could you post some close ups ?

18th May 2007, 06:22 PM	#6
Tim Simmons Member Join Date: Dec 2004 Location: What is still UK Posts: 5,925	I still need one like that Lew . Here are some close ups of this blade just enough to get the gist of it. The finger is not the most elegant measure of the blade but it does show the keen edge. The centre rib is approx 1cm wide and as I mentioned 5mm thick. The blade edge is slightly opposed curves, giving strength in structure if not the finest steel. I really like African metalwork that shows the smiths working marks. I do not think they had heard of William Morris and the arts and crafts movement . can I see a relation to some blades further south?