New Rencong Meucannge comments and advice

Rick · 23rd May 2013, 04:24 AM

Possibly one might apply a very tiny drop of say, acrylic artist's paint or some substance that will leave a mark to the center of one part .
Then carefully and very lightly press the parts together in the proper aligned position .
Pull them apart and you will have, at least a rough idea from the residue of where to drill on each part .

Yeah, there was a previously repaired/restored break in that spot .

Battara · 23rd May 2013, 05:12 AM

I agree with Alan, although I was thinking of water buffalo horn or strong wood. A metal pin will do to. I would use the epoxy instead of superglue for the reasons Alan mentions and for another reason - superglue does not fill in gaps.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

23rd May 2013, 04:24 AM	#1
Rick Vikingsword Staff Join Date: Nov 2004 Posts: 6,376	Possibly one might apply a very tiny drop of say, acrylic artist's paint or some substance that will leave a mark to the center of one part . Then carefully and very lightly press the parts together in the proper aligned position . Pull them apart and you will have, at least a rough idea from the residue of where to drill on each part . Yeah, there was a previously repaired/restored break in that spot .

23rd May 2013, 05:12 AM	#2
Battara EAAF Staff Join Date: Dec 2004 Location: Louisville, KY Posts: 7,345	I agree with Alan, although I was thinking of water buffalo horn or strong wood. A metal pin will do to. I would use the epoxy instead of superglue for the reasons Alan mentions and for another reason - superglue does not fill in gaps.