Bifurcated serrated Tulwar repair

Kmaddock · 11th March 2021, 08:32 PM

Picture before I started, found it on my phone message from when the seller offered me the some items.

I am very sorry I did not document the process but I did not think it was going to work out as well as I feel it did.

The process of bending the donor blade was quiet tricky and looked like it was doomed for failure but perseverance, a blow torch and swearing paid off!

when the blade initially snapped some one must have glued the broken bit on and had a splint of plastic at the joint, you can sort of see this in the picture.

Regards
Ken

11th March 2021, 08:32 PM	#7
Kmaddock Member Join Date: May 2014 Location: Ireland Posts: 543	Picture before I started, found it on my phone message from when the seller offered me the some items. I am very sorry I did not document the process but I did not think it was going to work out as well as I feel it did. The process of bending the donor blade was quiet tricky and looked like it was doomed for failure but perseverance, a blow torch and swearing paid off! when the blade initially snapped some one must have glued the broken bit on and had a splint of plastic at the joint, you can sort of see this in the picture. Regards Ken Attached Images

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode