A cutter ... to cut what ?

fernando · 11th September 2022, 01:55 PM

I realize this has to do with tobacco (smoking) artifacts, as influenced by the (Dutch i guess) maker's name SAMSON. Whatever it cuts, it cuts something; not cigars, as the admitter is too narrow; even too narrow for cigarrettes. Could it be for cutting filters, out of a rod ? The working steps comprehend (1) to introduce the whatever material and hold it inside the device with the intended length(1 and 1a) by turning up the striated front part; only leaving a very narrow section. Then we open and turn up the upper bar by releasing its back lock (2, 2a, 2b). Next thing you we close the bar and the V shape blade it has will meet its counterpart on the device base, dropping the whatever cut off bit through the bottom opening (3).
Any ideas, Gentlemen ?

.

11th September 2022, 01:55 PM	#1
fernando (deceased) Join Date: Dec 2004 Location: Portugal Posts: 9,694	A cutter ... to cut what ? I realize this has to do with tobacco (smoking) artifacts, as influenced by the (Dutch i guess) maker's name SAMSON. Whatever it cuts, it cuts something; not cigars, as the admitter is too narrow; even too narrow for cigarrettes. Could it be for cutting filters, out of a rod ? The working steps comprehend (1) to introduce the whatever material and hold it inside the device with the intended length(1 and 1a) by turning up the striated front part; only leaving a very narrow section. Then we open and turn up the upper bar by releasing its back lock (2, 2a, 2b). Next thing you we close the bar and the V shape blade it has will meet its counterpart on the device base, dropping the whatever cut off bit through the bottom opening (3). Any ideas, Gentlemen ? . Attached Images Last edited by fernando; 12th September 2022 at 07:29 AM. Reason: Spell