Yeah, I did --- get confused I mean.
Like they say:- speed kills.
Where the only pamor visible is the line that follows the edge, this is Pamor Wengkon, most pamor wengkon blades are made without any carved characteristics, like kruwingan & etc, they are usually dhapur brojol, or at best Tilam Upih.
When a blade is made with Pamor Wengkon, & it has deep kruwingan & etc, it is a blade that has been made in a way that went out of use a long time ago, by providing a body of plain iron, then inletting a steel edge, and laying down the pamor to follow the edge & then placing plain iron over it. When a blade has been made this way, there is no side to side layer of pamor, & you can go into it as deep as you like and not find pamor. But as I said, people have not made blades like this in more than maybe 200 years, it was simply too hard.
When a blade is made with a wengkon, sometimes that wengkon will be overlaid with another pamor, which is usually Wos Wutah, but depending on the skill of the maker, other more complex pamor motifs might also be used.
Gavin, yes, that pendok is an extremely fine piece of work.
|